Mar 15, 2025 #9 I'm quite confident 2k just signifies large Develop. The important section is compatibility with bare steel. So what you would like is really a higher Make direct to metallic (not acid etch) primer. This will likely fill in small imperfections, and offer you a sandable base. Even though it claims metallic, it is going to adhere just good towards your paint. I'm recommending the excel as it will work for you in excess of the bare and painted areas, and can help you save you from having to obtain numerous primers.
I'd personally propose obtaining the total issue in primer and sanded. Then you mask off for the colour you ought to spray that working day. Spray a single coloration, peel off your tape and Enable it cure. Up coming day remask for the next coloration and spray.
If I have an understanding of this appropriately, it seems like you intend to make use of the epoxy and urethane in one spray session. I have never ever tried using to do it by doing this, so Verify with your provider regarding the chemical compatibility of The 2.
obtaining offset wrench and cut so wrench can go the u joint manager and heat using welding contact to bend to have the appropriate angle can help. I had to pay a MerCruiser shop to acquire all the things back together and they still could not get sensors adjusted, but at the least my sensor wires and many of the boots are new. I also uncovered the factory wire connectors want to pop unfastened so Examine the electrical connections to start with. My fails are posted to my you tube channel which you could discover by question on MerCruiser 3.seven matter or alpha one sensor substitution video clips. I hope this facts helps Click to develop...
The instructions condition it has to be sanded following the recoat window but when implementing a topcoat or extra primer within the recoat time it doesnt need to have sanding as its not completely cured, boat finder that will provide a chemical bond of The 2
The antisiphon must be in the machine Found just from the gas pickup connector (major appropriate). During the provided image the valve need to be in the fitting ideal in between the top on the tube as well as the port Keeping the fuel pickup.
just attempted a thing: adverse to P and favourable to G pegs the gauge entire remaining if I jiggle it a tad. Unsure what that means. Sticky gauge possibly?
If you are doing regulate to discover acid etch, you will have to implement urethane or epoxy primer more than it or the acid can bleed in to the paint position. That is what my supervisor explained to me, I in no way applied it. Click on to develop...
It wouldn't be an issue when you Permit the epoxy dry, sanded, then used urethane. It'd be a concern although In the event the epoxy releases It really is chemicles to the urethane as it hasn't fully cured.
If you take way too extensive on a single facet, and the opposite aspect begins to flash, the overspray would not blend into the paint. You'll need dusty wanting traces during the paint.
I would like to maneuver up to a dually since I might want to travel to diverse boating locations. I might make out better with value and update if I'm going with out it staying a 4x4. So do I really need a 4x4 to launch my boat? What is actually your thoughts.....
Captain Caveman said: You presently answered your personal question. You must get 4x4 if you're traveling to unknown boating locations.
That signifies to me the gauge is just sticky and doubtless no excellent. Is there a means to “unstick” a gauge like this or simply greater to switch it?
does any individual have suggestions on the process, and also the paint and primer kinds to utilize to provide this its greatest benefits? I’ve acquired reasonable knowledge with painting and may be using a HVLP gun for paint and primer software.